A smooth sharp edge will increase the overall carving performance of a snowboard as well as edge hold on hard packed snow and icy conditions. If your board is showing any of these signs–your edges need to be sharpened!Ī properly sharpened edge will take off some of your fingernail when scraped against it. The board’s edges should be sharpened when there are nicks, burrs, rust, or the edge is dull. To do this, hold the file at a 10-15 degree angle and lightly run the file down the edge. Step 2: From the contact points inward, dull the edge 1”-2”. To find the main contact point, put the board on its side, look toward the tip or tail (where the board is starting to upturn) and you’ll see a line where the sidewall ends and another piece starts. This is the part of the board that is most often coming into contact with the snow underneath. Step 1: Locate the main contact point on a snowboard. To detune your snowboard edges you’ll need: This will affect the board’s edge permanently. However, be careful because if you detune more than 2” from the contact points you cannot bring the edge back. Riders who want to make sure they’re constantly detuning their board are those who are buttering, doing flat ground spin tricks, or sliding on rails and boxes. You want your edges to land in the middle of the spectrum of detuned and sharpened for the ideal ride. How to Detune Snowboard Edgesĭetuning an edge helps to allow the board to smoothly transition from edge to edge without the sharp new edge catching. If you want to do this yourself, check out our article “ How to Wax a Snowboard at Home“, otherwise, find a reputable snowboard shop that can help you wax your snowboard every few rides. Waxing your snowboard is one of the things you’ll do most often to keep it in top-tier shape.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |